Tipa

Timer with three adjustable time intervals and two time channels. Both times can be combined differently. Time range 0–999sec, 0–999min, 0–999h, settings apply to both channels simultaneously.


Technical parameters:

- power supply: 12 V
- 6 operating modes - see below
- relay contact 230VAC / 10A or 12VDC / 20A
- dimensions: 48 × 29 mm
- consumption in idle mode: 20 mA
- consumption with closed relay: 120 mA
- panel opening: 45.5 × 26 mm

Operating modes:
- P1–0: the relay closes permanently after time T1 has elapsed
- P1–1: the relay is closed for T1, then it switches off permanently
- P1–2: the relay closes for time T2 after the time T1 has elapsed, then the module is idle
- P1–3: the relay is closed for T1, then it is switched off for T2 and then it closes permanently
- P1–4: the relay switches cyclically to time T2 after time T1 has elapsed - it is switched off at the beginning of the cycle
- P1–5: the relay switches cyclically for time T1 after the time T2 has elapsed - it is switched on at the beginning of the cycle

Time setting:
- P0–0 - setting to seconds mode
- P0–1 - setting to minute mode
- P0–2 -set to clock mode

Settings:
- a short press of the SET button activates the time setting mode:
- T1 - the red display flashes and the time T1 can be set with the arrows
- T2 - the green display flashes and the time T1 can be set with the arrows
- saving of set values ​​is enabled by repeated short press SET or automatically after 6sec of inactivity
- long press of the SET button allows to set time units and operating modes:
-P0 - setting sec (0) - min (1) - hr (2) using the arrows. The settings apply to both channels at the same time
-P1 - setting of operating modes 0–5, see above, also with arrows.
- saving of set values ​​is enabled by repeated short press SET or automatically after 6sec of inactivity

The module does not have a separate Start button. The timing starts by connecting the input voltage

The product is not a stand-alone unit, it requires professional installation.