Tipa

Water and dust resistant charger with built-in Bluetooth technology, allowing you to view information from your charger to your smartphone, tablet or computer. Optimal for batteries with a capacity of 20-60Ah.

-Built-in Bluetooth technology for setting, voltage and current display
-Resistance to dust, water and chemicals
-Intelligent seven-stage charging algorithm
-Restores fully discharged "dead" batteries
-Automatic power function
-Resistant to low temperatures down to -30 ° C
-Several other features increase battery life
-Low power mode for charging small batteries
-Special mode for charging Li-ion batteries

Bluetooth
You can set up, view and configure the Blue Smart IP65 charger via your smartphone. You can view the status of the charger and battery. Even control charger functions with VictronConnect. The default voltage and current value is displayed on the screen. You can download the application for iOS and Android here. You can also download the VictronConnect app for free on Google Play or in the App Store.

Regeneration
The condition of a lead-acid battery that has already been undercharged or left discharged for several days or weeks will deteriorate due to sulfation. If detected in time, sulfation can sometimes be partially reversed by charging with low current before the battery reaches a higher voltage.

Recovery function for fully discharged batteries
Most reverse polarity chargers do not recognize low or near zero voltage batteries and will not start charging them. However, the Blue Power Charger will try to charge even a fully discharged battery with low current and restore normal charging as soon as sufficient voltage appears at the battery terminals.

Ultra-efficient "green" battery charger
With efficiencies of up to 95%, these chargers produce up to 4 times less heat than the industry standard. When the battery is fully charged, power consumption is reduced to 0.5 W, which is 5 to 10 times better than the standard.

Long service life, safety and quiet operation
-Low thermal load of electronic components.
-Protection against ingress of dust, water and chemicals.
-Protection against overheating: the output current will decrease with increasing temperature up to 60°C, but the charger will not fail.
-Chargers are completely silent: they do not contain an active cooler (fan) or other moving parts.

Storage mode: less corrosion of positive electrodes
Even a lower holding charge voltage following the absorption phase can cause corrosion of the grid. It is therefore essential to further reduce the charging voltage if the battery remains connected to the charger for more than 48 hours.

Charging with temperature compensation
The optimum charging voltage for a lead-acid battery is the opposite of its temperature. The Blue Power IP65 Charger measures the ambient temperature during the test phase and compensates for it during charging. The temperature is measured again when the charger is in low current mode during maintenance or storage. Therefore, no special settings are needed for cold or hot environments.

Charging mode for Li-ion batteries
The Blue Power Charger uses a special charging algorithm for Li-ion (LiFePO4) batteries, with an automatic reset of the Li-ion battery undervoltage protection.

Normal charging voltage mode 28.8V - suitable for gel and AGM batteries. 29.4V high charging voltage mode - suitable for open topped up liquid batteries.

Technical data:
Input voltage: 180 - 265 V AC
Frequency: 45 - 65 Hz
Charging current: 5 A
No-load power consumption: 0.5 W
Absorption charging voltage: 28.8 V
Trickle charge voltage: 27.6 V
Storage mode voltage: 26.4 V
Protections: output polarity reversal, output short circuit, overheating
Operating temperature range: from - 30 to + 50 ° C
Humidity: maximum 95%
Battery output: black and red cable 1.5 m long
230 V AC charger input: 1.5 m cable with standard plug
Degree of protection: IP 65
Plug Type: CEE7 / 7 (Schuko)
Weight: 0.9 kg
Dimensions (height x width x length): 47 x 95 x 190 mm