Tipa

A set of quality LEVEL SYSTEM T-HOLD leveling clamps for leveling tiles and wall tiles. These clamps are used in combination with leveling wedges and pliers during the laying of tiles in a plane - insert the clamps into the joints according to the width of the joint, insert the wedge into the clamp and use special leveling pliers to level the tiles or wall tiles in a plane. Once the adhesive under the tiles has hardened, use a rubber mallet to knock the clamps, fill the joints and you're done. The wedges, pliers and mallet are not part of this set and must be purchased separately as needed.

Easy, fast and precise laying of tiles and wall tiles
Eliminates height inequalities between tiles and wall tiles, so-called lippage
Suitable for tiles and wall tiles of all materials and shapes

Usage:
1. During laying, insert clamps with a width according to the desired joint width into the joints between tiles or wall tiles.
2. Insert the wedges into all clamps.
3. Use the leveling pliers to pull the first wedge into the clip until the tiles are level.
4. Screw the fixing screw on the pliers according to the first wedge to pull the rest of the tiles or tiles with the same force.
5. Tighten the rest of the wedges.
6. After the adhesive has set (usually after 24 hours), remove the clips by hitting them with a rubber mallet from the side in the direction of the joint.
Note: The wedges can be used repeatedly.
Note: The joint must be clean to remove the clips correctly with a mallet.

Technical parameters:

Thickness: 1 mm
Width: 36 mm
Height: 40 mm
Material: plastic
For tiles/tiles with a thickness of: 4 - 15 mm

Package contents:

200 x Leveling clips 1 mm