Tipa

Hybrid voltage converter CARSPA MKS3.5K, DC/AC 24V/3500W, MPPT controller. The device is a combination of pure sine wave inverter, UPS and MPPT controller for solar panels. It is therefore a backup source with backup by a public network or generator, a battery charger and an MPPT solar controller, while the backup priority can also be set inversely, i.e. priority of the public network and backup from batteries or PV panels.


Technical parameters:

- system voltage 24V
- inverter with pure sine wave
- max. battery charging current when operating from the network 80A (set 30A)
- max. battery charging current when operating from panels 110A
- adjustable AC or BAT priority
- compatible with generator or utility voltage, the inverter phases with the AC input, allowing the use of three identical inverters with monitoring relays to power three-phase systems
- protection against overload, short circuit and battery discharge
- automatic restart after overload
- intelligent battery charger
- usable batteries: lead AGM, AGM GEL, with liquid dielectric, LiFePO4
- for LiFePO4, the necessary parameters must be set in USE mode - only for experienced users
- soft start for gradual start-up of loads
- consumption in stand-by mode 10W
- solar panels with a max. no-load voltage of 120–500Va with a max. current of 20A. (max 5000W)
- RS232 communication

Notice:
- parallel or three-phase connection is not possible.
- we recommend a minimum voltage from PV panels of 160V.
- the values ​​shown on the display are indicative only and are only relevant when the load is connected.

The converter is intended for use only in TN-S or TN-C-S networks, according to the currently valid standards. When used in TN-C networks (two-wire, phase + working earth) there is a risk of damage or incorrect operation of the device.