Tipa

Penosil Foam Remover 995 is a solvent spray PU foam cleaner.
Softens hardened construction foam so it can be easily removed from tools and surfaces.
It can also be used to dissolve various finishes such as varnishes and paints.

METHOD OF USE
Shake the can vigorously, remove the cap and attach the spray nozzle to the valve.
Spray the product on the hardened foam that needs to be removed.
Do not spray on adjacent surfaces, as the product dissolves various surface treatments (varnishes, paints, etc.).
Allow the foam to soften for 5 to 10 minutes and then mechanically remove it.
If necessary, repeat the procedure.
Finally, clean the surface with a damp tissue or use cleaning wipes PENOSIL 941 (PE-3009).
Test the suitability of the product in advance, there is a risk of surface damage!
Not suitable for cleaning the inside of a foam gun.

TIPS
Air and can temperature during use: +5°C to +30°C.
To clean up product residues, cover the excess product with an inert absorbent (e.g. sand).
Collect it and place it in a suitable container or let it evaporate.

STORAGE
Store in closed original packaging in a dry place between +5°C and +30°C.
Protect from frost.
The container should not be exposed to a temperature higher than +50°C and kept near heat sources or in direct sunlight.

SECURITY REQUIREMENTS
Extremely flammable aerosol. The container is under pressure: it may burst when heated. If medical attention is needed, have the product packaging or label on hand. Keep out of reach of children. Keep away from heat, hot surfaces, sparks, open flames and other sources of ignition. No smoking. Do not spray on open flames or other sources of ignition. Do not puncture or burn even after use. Use only outdoors or in well-ventilated areas. Wear protective gloves/protective clothing/safety glasses/safety shoes. Protect from sunlight. Do not expose to temperatures exceeding 50°C. Dispose of contents/packaging according to local/regional/national/international regulations.