Tipa

Hand-mixed two-component epoxy putty reinforced with anti-corrosion steel for quick fixation and restoration.

- After mixing the activator and base in the inner and outer layers, a polymer mixture is created that can be shaped or used to repair, restore and patch metal parts.
- Easy to use, indispensable for small quick repairs.
- Consistency (similar to modeling clay) eliminates drips and runs, facilitates adhesion to the substrate and allows the material to be shaped and molded as needed before starting
curing. After functional curing (within a few minutes after application) it is possible to drill, cut, carve, grind,
file and paint. Resistant to water, chemicals and extreme temperatures.
- Does not contain solvents or volatile organic substances. It is non-flammable and does not emit any harmful fumes.
- Does not clump or separate.

Fields of application
Fills cracks and voids in metal. Seals leaks in pipe joints. Restoring the exposed
nail heads, small machine parts, corroded metal. Shaping tools of special shapes,
handles, prototype parts.

conditions of use
Suitable for indoor and outdoor use. Application temperature +5 °C to +30 °C. All surfaces must be
clean, without free particles. The unused portion will remain fresh for the next one after being stored in the original packaging
use. Not suitable for general construction work.
Can be used on surfaces coming into contact with drinking water.

Application instructions
Roughen and clean the repaired area before application.
Then follow these simple steps:
Cut or roll the desired amount.
Mix by kneading with your fingers to get a uniform color.
If mixing is difficult, warm FastFix Metal to room temperature or slightly warmer.
Even mixing is important to achieve good quality.
Apply to the repaired surface within 2 minutes after mixing.
Get into any cracks or holes and remove excess material, preferably with a tool moistened with clean water.
After applying sealant to a damp, wet or slowly seeping surface, press the material firmly against the surface and press until it adheres.
For best results, wet your fingers to better blend, apply and spread the cured product.
Remove excess material before curing.

Cleaning
Use water or PENOSIL Premium cleaning wipes to remove fresh sealant from hands and tools.
Cured sealant should be removed mechanically.

Technical parameters:

- Processing time: 3-5 min
- Curing time: 1 hour
- Transverse tensile strength: 6.2 MPa
- Compressive strength: 55MPA
- Density: 2.2g/cm3
- Upper temperature limits: long-term +120°C, short-term +150°C

Color
Cures to a dark gray metallic color.

Packaging
30ml stick individually packaged in a reusable clear plastic tube with instructions and plastic
friction lid.