Tipa

Appliance disconnector as protection against deep battery discharge. Maximum load current 220 A. Battery protection BatteryProtect disconnects the battery from insignificant loads before the battery is completely discharged (which would destroy it) or while it still has enough capacity to start the engine.

Automatic setting 12/24V:
- battery protection BatteryProtect automatically detects the voltage in the system.

Easily programmable:
- BatteryProtect protection can be set to connect / disconnect to several different voltage levels.
- the display divided into seven parts shows which setting was selected.

Special settings for Li-ion batteries:
- in this mode, the BatteryProtect can be controlled via the VE.Bus BMS bus.

Very low energy consumption:
- low consumption is very important for Li-ion batteries, especially after switching off at low voltage.
- for more information, please see Li-ion battery datasheet and VE.Bus BMS manual.

Overvoltage protection:
- in the event of an overvoltage resulting in possible damage to sensitive devices, the devices are disconnected if the DC voltage exceeds 16 V or 32 V.

Spark resistant:
- it does not work with relay elements but with MOSFET transistor switches, no sparking occurs.

Delayed alarm output:
- the alarm output is activated if the battery voltage drops below the set value for more than 12 seconds. Starting the engine therefore does not activate the alarm. The alarm output is an open collector output on the negative bus, max. current 50 mA. The alarm output is typically connected to a buzzer or light signaling.

Delayed load disconnection:
- the load is disconnected 90 seconds after the alarm was triggered. If during this time the battery voltage rises to the "connection threshold" level (e.g. during engine start), the load will not be disconnected.

BatteryProtect battery protection is one-way, i.e. the current can only pass from the "in" input to the "out" output. Reverse current passing from the output "out" to the input "in" is inadmissible and will damage the device.


Technical parameters:

- manufacturer: Victron Energy
- current: 220 A
- voltage: 12 V
- voltage: 24 V
- bluetooth: no