Tipa

Charger with automatic CFG12/24-10 for Pb and LiFePO4 batteries.
A smart, fully automatic charger for Pb and LiFePO4 batteries with a current of up to 10A, enabling a permanent connection with the battery being charged. It is equipped with a program for the regeneration of Pb batteries. 7-level charging.


Technical parameters:

- input voltage: 100-240VAC, 50-60Hz
- rated power: 12V 10A / 24V 5A
- minimum initial voltage: 7.0 V
- rechargeable batteries: Pb 12 or 24V, LiFePO4 3S-8S, Li-Ion 2S-7S
- battery capacity range: 6–180Ah (12V), 6–90Ah (24V)
- protection against polarity reversal
- short circuit protection
- surge protection
- protection against overheating
- ventilator
- thermal protection: 65 ° C +/- 5 ° C
- efficiency: App. 85%
- compliant standards: CB, CE, IEC60335, EN61000, EN55014
- dimensions: (L x W x H): 170 x 100 x 70 mm
- weight: 590 g

Instructions for use:
1) Connect the rechargeable battery to the charging terminals of the charger. This is indicated by an acoustic signal (beep) and the display lighting up. The display shows the battery terminal voltage.
2) Connect the charger to the mains. Now you have about 10 seconds to change the charging mode (AGM, CAR, MOTO, LiFePO4, REPAIR) Then the charger will automatically go into the charging phase. The phases of the charging cycle are shown on the circular indicator, the terminal voltage, charging current, ambient temperature and degree of charge are shown on the display.
3) After reaching the desired terminal voltage (for AGM batteries, the value is 14.4V), the charger switches to float mode with a maintenance voltage (for AGM, it is 13.5V)